Hardware » History » Revision 9
Revision 8 (Luiz Fernando Lavado Villa, 2019-02-28 14:19) → Revision 9/15 (Luiz Fernando Lavado Villa, 2019-02-28 14:43)
h1. Hardware
{{>toc}}
The hardware of the single-phase project consists of a 10cm by 10cm printed circuit board that hosts 5 electronics blocks.
These blocks all fulfill functions which are necessary to the proper operation of any power electronics converter.
Figure 1 illustrates these blocks.
p=. {{thumbnail(theory_power_converter_1.png, size=350, title=General overview title=Theoretical view of a power electronics converter)}}
_Figure 1 - General overview of a power electronics converter_
Each block is explained in detail in the sections below.
h2. Power Block
To better explain the Power Block, this page splits its presentation in theory and practice.
h3. Theory
The Power Block is the part that manages input/output power within the board.
It consists of a single inverter leg, as illustrated in the figure below.
p=. {{thumbnail(single_phase_topology.png, size=350, title=The power topology of the single-phase board)}}
_Figure 2 - The power topology of the single-phase board_
Figure 2 shows a Vlow, VHigh, T1, T2, D1, D2 and L.
Vlow is the low-side voltage, VHigh is the high-side voltage, T1 and T2 are two transistors, D1 and D2 are two diodes and L is an inductor.
This topology is current bi-directional.
This means that its input can be either on the high-side or on the low-side.
If the input is on the high-side, the circuit acts as a buck or step-down converter.
If the input is on the low-side, the circuit acts as a boost or step-up converter.
This topology allows the control of the current in the inductor L by controlling its charge and discharge using the switches.
The figure below shows the switching and the current flow within the inductor.
p=. {{thumbnail(states_converter_1.png, size=700, title=Current flow during switching)}}
_Figure 3 - The power topology of the single-phase board_
The switching leads to an average current flow between its input and output as shown in the image below.
p=. {{thumbnail(switching_states_1.png, size=700, title=Current flow during switching)}}
_Figure 4 - Left: average current in the inductor increases_
_Center: average current in the inductor stable_
_Right: average current in the inductor decreases_
As figure 4 shows, the key to control the current in the power converter is to control the duration of the signal that is sent to the transistors.
This duration is called *duty cycle* .
A longer duty cycle will lead to a increase in current, while a shorter duty cycle will lead to a decrease in current.
The duty cycle is the single most important control variable in a power converter.
The presentation above is, obviously, not complete since there are further phenomena to be taken into account.
The instantaneous rise and fall in current will lead to abrupt variations in voltage at both the high and low sides.
To filter these variations, power converters are equipped with capacitors in both sides, which effectively provide the instantaneous current needed by the converter.
The relationship between high and low side voltages, high and low side currents, and the duty cycle is given by the equations below.
* Boost mode
p=. !http://www.codecogs.com/eq.latex?\dfrac{V_{High}}{V_{Low}}=\dfrac{I_{Low}}{I_{High}}=\dfrac{1}{1-D}!
* Buck mode
h3. Practice
h2. Measurement Block
h2. Control Block
h2. Driver Block
h2. Feeder Block