Wiki DLP4100 » History » Revision 3
Revision 2 (Frédéric Blanc, 2017-04-18 16:07) → Revision 3/60 (Frédéric Blanc, 2017-04-21 12:30)
p=. *Wiki DLP4100* h1. Overview The DLP® Discovery™ 4100 (D4100) is the latest in a series of spatial light modulation development kits from Texas Instruments. Users of the D4100 Starter Kit have the ability to manipulate visible, ultraviolet and near-infrared light with extremely high performance and high resolution. The D4100 offers developers a flexible platform to design products to fit most any application using the proven reliability of DLP technology. !D4100_Starter_Kit_Block_Diagram.PNG! Fig 1: System Overview h2. Configuration Jumpers !D4100_Controller_Configuration_Jumpers.PNG! Fig 2: D4100 Controller Configuration Jumpers *J2 – EXP Voltage Select* *J4 – Used to select the revision of firmware loaded from the PROM to the APPSFPGA.* |_.Jumper Position|_.Revision Version| |open|0| |close|1| *J5 – Shared USB signal disabled* |_.Jumper Position|_.USB Signals| |0-1|Disconnected from FPGA | |1-2|Connected to FPGA| |2-3|Automatically connect USB signals to FPGA when USB is connected to host PC | *J7 – USB EEPROM Programming Header* Used to temporally disconnect the USB EEPROM fromthe device so the device can load its internal boot loader rather than any code in the EEPROM. Install J8 for Cypress internal boot loader. *J10 – DAD2000 B Output Enable* Used to enable the outputs for DAD2000 B. This needs to be enabled only if using the 1080p DMD, otherwise this can be disabled. |_.Jumper Position|_.DAD2000 B Outputs| |open|Disabled| |close|Enabled|