OwnTech » OwnPower » single-phase

h1. Hardware

{{>toc}}

The hardware of the single-phase project consists of a 10cm by 10cm printed circuit board that hosts 5 electronics blocks. 

These blocks all fulfill functions which are necessary to the proper operation of any power electronics converter. 

Figure 1 illustrates these blocks. 

p=. {{thumbnail(theory_power_converter_1.png, size=350, title=Theoretical view of a power electronics converter)}}

Each block is explained in detail in the sections below. 

h2. Power Block

The Power Block is the part that manages input/output power within the board. 

It consists of a single inverter leg, as illustrated in the figure below. 

p=. {{thumbnail(single_phase_topology.png, size=350, title=The power topology of the single-phase board)}}

This topology allows the control of the current in the inductor L by controlling its charge and discharge using the switches. 

The figure below shows the switching and the current flow within the inductor. 

p=. {{thumbnail(states_converter_1.png, size=350, title=Current flow during switching)}}

h2. Measurement Block

h2. Control Block

h2. Driver Block

h2. Feeder Block